ProPeler
Home
Console
Upload
information
Create File
Create Folder
About
Tools
:
/
lib
/
modules
/
5.4.0-216-generic
/
build
/
fs
/
jbd2
/
Filename :
Kconfig
back
Copy
# SPDX-License-Identifier: GPL-2.0-only config JBD2 tristate select CRC32 select CRYPTO select CRYPTO_CRC32C help This is a generic journaling layer for block devices that support both 32-bit and 64-bit block numbers. It is currently used by the ext4 and OCFS2 filesystems, but it could also be used to add journal support to other file systems or block devices such as RAID or LVM. If you are using ext4 or OCFS2, you need to say Y here. If you are not using ext4 or OCFS2 then you will probably want to say N. To compile this device as a module, choose M here. The module will be called jbd2. If you are compiling ext4 or OCFS2 into the kernel, you cannot compile this code as a module. config JBD2_DEBUG bool "JBD2 (ext4) debugging support" depends on JBD2 help If you are using the ext4 journaled file system (or potentially any other filesystem/device using JBD2), this option allows you to enable debugging output while the system is running, in order to help track down any problems you are having. By default, the debugging output will be turned off. If you select Y here, then you will be able to turn on debugging with "echo N > /sys/module/jbd2/parameters/jbd2_debug", where N is a number between 1 and 5. The higher the number, the more debugging output is generated. To turn debugging off again, do "echo 0 > /sys/module/jbd2/parameters/jbd2_debug".